Compensation Of Turning; Parallel Section Turning Compensation; Eyelet Crosswise Compensation; Eyelet Lengthwise Compensation - JUKI MEB-3200 Manuel D'utilisation

(3) Compensation of turning

1

(4) Parallel section turning compensation

1
Settng range s － 14 ≦ compensaton of turnng ＋ compensaton of turnng at parallel secton ≦ 14.

(5) Eyelet crosswise compensation

1

(6) Eyelet lengthwise compensation

1

(7) Left eyelet lengthwise compensation

1

＋
−
2
2
− ＋
2
＋
−
2
−
＋
2
Turning angle of the eyelet section and of
the parallel section can be adjusted.
Set the turnng angle wth [RIGHT
[RIGHT ] key 2 .
Settng can be performed − 14˚ to 14˚.
Turning angle of parallel section and
bottom of eyelet can be adjusted.
Set the turnng angle wth [RIGHT
＋
[RIGHT ] key 2 .
W h e n t h e t u r n  n g c o m p e n s a t  o n o f t h e
−
a f o r e m e n t  o n e d ( 3 )  s p e r f o r m e d , t h e
compensaton s performed n the form of addng
the compensaton value of turnng of (3).
Position on the top of eyelet can be
moved to the right- or left-hand.
Set the poston wth [RIGHT
] key 2 .
Settng can be performed − 0.6 to 0.6 mm n the
ncrements of 0.1 mm.
Shape on the top of eyelet can be expanded
or contracted in the longitudinal direction.
Set the poston wth [RIGHT
] key 2 .
Settng can be performed − 0.2 to 0.6 mm n the
ncrements of 0.1 mm.
Length of the left side on the top of eyelet
can be adjusted.
Set the length wth [RIGHT
] key 2 .
Settng can be performed − 0.2 to 0.6 mm n the
ncrements of 0.1 mm.
] key 1 or
] key 1 or
] key 1 or [RIGHT
] key 1 or [RIGHT
] key 1 or [RIGHT