Setting The Pattern Data Of Cloth Cutting Knife Pressing Amount - JUKI MEB-3200 Manuel D'utilisation

(8) Setting the pattern data of cloth cutting knife pressing amount

The cloth cuttng knfe pressng amount can be set to the pattern data, and even when the knfe holder s
replaced, the knfe adjustment s not performed. The settng can be completed by changng the pattern No.
only.
The knfe holder No. 0 to 9 up to 10 knds are set to the pattern data No. 28 and the knfe pressng amounts
can be set to each of knfe holder Nos.
1) Set memory swtch No. 40 to "1".
■ Adjusting the knife pressing amount
7
6
2
3
1
For the caution regarding adjusting the cloth cutting knife pressure, refer to (2) Adjusting the cloth
cutting knife pressure on page 27.
■ Pattern data setting procedure
2 4
3

1) Pressng [ADJUST
8
2) The knfe holder No. s dsplayed n 2-dgt LED and the knfe pressng
amount whch has been set to each knfe holder No. s dsplayed n
4-dgt LED 8 .
3) Press [READY
feed base and the cloth cuttng knfe perform orgn retreval.
4) The knfe holder No. desred to be set can be set wth [LEFT
or [LEFT
5
5) The knfe pressng amount n terms of the knfe holder No. dsplayed n
4
the 2-dgt LED can be set wth [RIGHT
5 . The settng range s -100 to 300. The more the number s, the hgher
the cloth cuttng knfe pressure becomes.
6) Lower the presser wth the presser swtch and press the start swtch to
actuate the knfe. The knfe holder No. can be set agan wth the presser
rased usng [LEFT
pressng amount can be set agan usng [RIGHT
] key 5 .
7) Press [ADJUST
adjustment mode ends.
The set value is stored in memory when the knife is actuated by
the start switch or [ADJUST
the knife holder No. without performing either operation, or turning
OFF the power, the setting is not stored in memory.
1) Press [LEFT
28.
5
2) Press [RIGHT
No. 0 to 9 can be set.
] key 1 , turn ON the power.
] key 6 to lght up the sewng LED. At ths tme, the
] key 3 . The settng range s 0 to 9.
] key 2 or [LEFT
] key 1 after completon of settng and the knfe
The knife holder No. to which the knife pressing
amount has been set is set.
For the data setting procedure, refer to Compensation
of the data on page 31.
] key 2 or [LEFT
] key 4 or [RIGHT
] key 4 or [RIGHT
] key 3 . In addton, the
] key 4 or [RIGHT
] key 1 is pressed. When changing
] key 3 to dsplay data No.
] key 5 to set the data
] key 2
] key