Setting The Number Of Stitches Of The Parallel Section; Setting The Number Of Stitches Of The Eyelet; Setting The Cut Space; Setting The Eyelet Space - JUKI MEB-3200 Manuel D'utilisation

(4) Setting the number of stitches of the parallel section

1

(5) Setting the number of stitches of the eyelet

1

(6) Setting the cut space

1

(7) Setting the eyelet space

1
2
2
2
Clearance
Clearance
Clearance
2
Set the number of stitches from the parallel
section to the bottom section of eyelet.
Set the number of sttches wth [RIGHT
or [RIGHT ] key 2 .
1. The number of stitches can be set to
such an extent of 3 to 100 stitches. The
number of stitches that can be set is
limited by the set value of cut length.
Example) When the cut length is equal to
22 mm, the number of stitches is 6 to
41 stitches. In addition, if the number
of stitches is decreased, the number
of revolution of the sewing machine
automatically reduces.
2. For T type, looper thread can be neatly
rolled in at the start of sewing by
increasing the number of stitches.
Set the number of stitches of the top
section of eyelet.
Set the number of sttches wth [RIGHT
or [RIGHT ] key 2 .
The number of sttches can be set 4 to 20 sttches.
Set the clearance where the knife drops
in the parallel section.
Set the cut space wth [RIGHT
] key 2 .
The space can be set − 1.2 to 1.2 mm n the
ncrements of 0.1 mm.
Set the clearance where the knife drops
in the eyelet section.
Set the eyelet space wth [RIGHT
[RIGHT ] key 2 .
The space can be set − 1.2 to 1.2 mm n the
ncrements of 0.1 mm.
] key 1
] key 1
] key 1 or [RIGHT
] key 1 or