Setting Of The Mounted Machine Head - JUKI SC-922 Mode D'emploi

1. SETTING OF THE MOUNTED MACHINE HEAD

(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the Instruc-
tion Manual for the operation panel to be used.
❸ ❹
❸ ❹
❸ ❹
❸ ❹
❺ ❻ ❼
❺
❻
❺
❻
❺
❻
– 1 –
1) How to enter into the function setting
mode
Turn ON the power with
❼ held pressed. (The item which has
been changed during the previous
work is displayed.)
* If the screen display does not change,
re-carry out operation described in
step 1).
(Caution)
Be sure to re-turn ON the power switch
when one or more seconds have passed
after turning it OFF. If the power switch is
re-turned ON immediately after turning it
OFF, the sewing machine may fail to op-
erate normally. In such a case, be sure to
turn ON the power switch again properly.
switch ❸ or
2) Press
❹ to call out function setting No.95
(mounted head).
switch ❺ or
3) Press
❻ to select the mounted head. Refer
to Table 1 (p.2) for the relationship
between the head type and the panel
display.
4) After selecting the head type, press
switch ❸ or switch ❹ , and
turn the power OFF.
(Caution)
If the power is turned OFF before car-
rying out this procedure, the changed
content is not updated. When
❸ is pressed, the display on the pan-
el changes to the previous setting No.
switch ❹ is pressed, the dis-
When
play on the panel changes to the subse-
quent setting No. After completion of the
operation, the machine is returned to the
normal sewing state by turning OFF the
power and re-turning it ON.
switch
switch
switch
switch