Changing Procedure Of The Sewing Pattern; Confirming The Pattern Shape - JUKI MEB-3200 Manuel D'utilisation

(9) Changing procedure of the sewing pattern

5
4
2
3
1

(10) Confirming the pattern shape

3
5
4
0
1) Make sure that sewng LED 4 goes out.
(When the LED lghts up, press [READY
to make t go out.)
2) Press [PATTERN
No.
3) Press [LEFT
select the pattern you desre to sew.
(The number of pattern whch s not regstered s
not dsplayed.)
4) Press [READY
4 and to make t possble to sew.
1) Press [READY
1
4 and to make t possble to sew.
2
2) Lower the presser wth the presser swtch.
3) Every tme [FORWARD
key 2 s pressed, the feed mechansm travels
forward/backward sttch by sttch and contnually
moves up to the poston of the sewng end.
In addton, the feed mechansm contnually
travels when keepng the key held pressed.
4) After completing the confirmation of the sewing
pattern, press [RESET
machne to ts set poston.
] key 1 to dsplay the pattern
] key 2 or [LEFT
] key 5 to lght up sewng LED
] key 5 to lght up sewng LED
] key 1 or [BACK
] key 3 to return the
If the START switch is pressed during
confirmation of the pattern shape, sewing
starts from the position where the switch is
pressed. So,be careful.
] 5 key
] key 3 to
]