Operating Procedure Of Thread Tension Compensation Of Each Section - JUKI MEB-3200 Manuel D'utilisation

(2) Operating procedure of thread tension compensation of each section

7
1
4
3
2
1
0
Thread tension of each section of the
sewing shape can be individually changed.
Thread tension at each section is needle
thread tension set value (No. 40) or looper
thread tension set value (No. 60) to which
5
each compensation value has been added.
1) Make sure that the sewng LED 7 has gone out.
6
When t lghts up, press [READY
make t go out.
2) Press [DATA
3) Select the compensaton poston No. of each
tenson wth [LEFT
4 . (For the compensaton poston No., refer to
the separate tables 1 and 2.)
4) When the compensaton poston No. s selected,
nput the set value wth [RIGHT
[RIGHT
5) Press [READY
stored n memory.
Both needle thread and looper thread can
be set with the same operation. When
changing the pattern No. without performing
the operation of step 5) or turning OFF the
power, the set value is not stored in memory.
For the cpmpensation position No., refer to
tables 1 and 2 and Figs. 1 and 3.
■ Performing the compensation of
thread tension in the state of sewing
Settng of compensaton of thread tenson and
confrmaton of sewng can be performed wthout
4
performng the operaton of [READY
5
1) Make the memory swtch No. 19 = 1.
2) Drectly ndcate the compensaton poston No. wth
[NEEDLE
3
3) Set the compensaton value wth [RIGHT
4 or [RIGHT
4) When pressng [READY
2
sewng wth the start swtch, the set value s
stored n memory.
When changing the pattern No. without
performing the operation of step 4) or
turning OFF the power, the set value is not
stored in memory.
] key 2 .
] key 3 or [LEFT
] key 6 .
] key 1 and the set value s
] key 1 .
] key 2 or [LOOPER
] key 5 .
] key 1 or startng
] key 1 to
] key
] key 5 or
] key 3 .
] key