JUKI MEB-3200 Manuel D'utilisation page 25

1
2
Insert thread
in the groove.
1. When passing the looper thread, turn the looper bracket by 180˚ and pass it.
2. Pass the looper thread and gimp through the needle hole in the throat plate and pull them out from
hole 1 . Then clamp them at 2 of the presser plate and perform a few stitch sewing to remove the
looper thread and gimp (2 pcs.). When the sewing is completed, the looper thread is retained with
the looper thread clamp and gimp with the gimp clamp. If thread waste is clamped, remove it since
clamping becomes incomplete and stitch skipping at the sewing start will be caused.
[Refer to the item "(9) Adjusting the looper thread trimming" on page 53.]
3. In case of T type, when performing sewing immediately after threading, place backward the
looper thread through the needle hole in the throat plate and perform partial sewing, or retain the
looper thread on the looper thread presser and perform sewing. [Refer to the item "(9) Adjusting
the looper thread trimming" on page 53.]