Electrical Wiring, 12-30 Vdc Version - Burkert 8035 Manuel D'utilisation

3 INSTALLATION
3.3.4

Electrical wiring, 12-30 VDC version

Before wiring the device, please read § 3.3.1, 3.3.2 and 3.3.3 carefully.
Lift the transparent lid after having unfastened the screw. Remove the cover of the device by
unscrewing the 4 screws, pass the cables through the cable glands and connect according
to the pin assignment below.
Always seal the unused cable gland using the supplied obstructor to en-
sure the tightness of the device.
Unscrew the cable gland nut, insert the obstructor and screw the nut back
onto the cable gland.
Only manipulate the switches when the device is not powered.
Connect the shielding of IN binary inputs and OUT
output cable
"Batch status indication" output
Binary inputs, volume selection
Fit here the cables using
the supplied cable clips
(see § 3.3.2)
Type 121
Solenoid valve
This version enables the controller power supply to be used for inputs IN1 to IN4 and output
OUT: in that case, connect terminal 6 (COMMON) to terminal 9 (L-).
Fig. 4 Electrical wiring 8035, 12-30 VDC version
Common
{
1 2 3 4 5 6 7 8 9 10 11
12..30Vdc
NPN SENSOR BINARY
1 PULSE INPUT
2 -
SUPPLY
3 +
4 NC
COIL SENSOR
NC
L+ (L+)-12V
1 2 3 4 PE
SENSOR SUPPLY
3A/230VAC
FLOW SENSOR
Relay cables must
be fitted here to the
board using the sup-
plied cable clips (see
§ 3.3.2)
E-12-
BATCH CONTROLLER 8035
L+ (12-30 VDC)
L- (0V)
Connect the power supply cable shielding
see § 3.3.3
Supply
COIL NPN
SENSOR INPUT
Not used
Connect the flow rate sensor
Type 142
Solenoid valve