How To Use The Cable Clips; Using Switches Sensor Input And Sensor Supply - Burkert 8035 Manuel D'utilisation

3 INSTALLATION

3.3.2 How to use the cable clips

Before wiring the device, insert the supplied cable clips into the cuts of the electronic board
and, if fitted, into the cut of the 115/230 VAC power supply board.
Fig. 3 Using the cable clips

3.3.3 Using switches SENSOR INPUT and SENSOR SUPPLY

Before wiring the device, make sure that switch SENSOR INPUT of the electronic board is
correctly positioned.
8035 Batch
Compact versions
BATCH CONTROLLER 8035
SENSOR INPUT SENSOR SUPPLY
switch
NPN no effect
E-11-
switch