Hettich ROTO SILENTA 630 RS Mode D'emploi page 94

Software operation
Changing a program link
7.8.2 Centrifugation run with program link
40 / 50
[STO] button twice.
5. Press the
�� The program is linked and the program number of the next pro-
gram location (+XX+) is displayed.
[RCL] button twice.
6. Press the
�� The centrifugation data of the desired program location is dis-
played
7. Press the [STO] button twice.
�� The program is linked and the program number of the next pro-
gram location (+XX+) is displayed.
8. Repeat the last two steps until all programs are linked.
[PROG] button.
9. Press the
�� The program number of the end program (+XX) is displayed.
1. Open the desired program.
2. Change the desired parameter.
3. Save the changed centrifugation data to the same program location
again.
�� Saving removes the program link.
4. Link programs again.
[PROG] button twice.
1. Press the
�� Parameter PR-PART is selected.
The input field is reverse highlighted.
[Rotary knob] to set the program location of the initial pro-
2. Use the
gram (XX+).
[RCL] button.
3. Press the
�� The centrifugation data of the desired program location is dis-
played
4. Press the [START] button.
�� The centrifugation run is started.
'Rotation' indicator appears as long as the rotor is turning.
The
The ramp-up and brake levels of the program link are displayed.
■
Initial program (XX+)
x: Ramp-up level of the initial program x
■
Follow-up program (+XX+)
x: Ramp-up level of the follow-up program x
■
End program (+XX)
x: Ramp-up level of the end program
y: Brake level of the end program
5. Ramp-down takes place with the brake level of the end program after
the time in the end program has elapsed.
If the centrifugation run is cancelled by pressing the
ramp-down takes place at the brake level of the program currently
running.
Rev.: 20 / 01.2024
[STOP] button,
AB5005en