Hettich ROTO SILENTA 630 RS Mode D'emploi page 75

5 Commissioning
5.1 Unpacking the centrifuge
AB5005en
CAUTION
Danger of crushing due to parts falling out of the transport
packaging.
−
Keep the device balanced during the unpacking
process.
−
Only open the packaging at the points provided for this
purpose.
CAUTION
Risk of injury from lifting heavy loads.
−
Provide an adequate number of helpers.
−
Note the weight. See ⮫
on page 10 .
NOTICE
Damage to the device due to improper lifting.
−
Do not lift the centrifuge by the control panel or the
control panel holder.
Personnel:
■
Trained user
4
3
Fig. 27: Unpacking
1 Flat
2 Device feet
3 Metal rail
4 Wooden beams
1. Remove the packaging.
2. Remove the wooden beam (
3. Attach the metal rails (
4. Slide the wooden beam (
5. Place an open-end spanner (size 10 mm) on the surfaces (
the device feet ( 2 ) upwards as far as possible.
6. Carefully roll the centrifuge off the wooden pallet over the metal rails
3 ).
(
Rev.: 20 / 01.2024
Chapter 3.1 'Technical data'
2
4 ).
3 ) to the wooden pallet using two nails each.
4 ) under the metal rails ( 3 ) to support them.
Commissioning
1
2
1 ) and turn
21 / 50