Hettich ROTO SILENTA 630 RS Mode D'emploi page 93

7.7.5 Setting the date and time
7.8 Program links
7.8.1 Linking programs or changing a program link
Linking programs
AB5005en
[START] button.
4. Press the
�� The settings are stored.
'*** OK ***' is displayed briefly.
The rotor is stationary.
1. Open the lid.
2. Press and hold the
'SOUND / BELL' is displayed after 8 seconds.
��
[t] button twice.
3. Press the
�� The date and time are displayed
a: Year
mon: Month
d: Day
h: Hours
min: Minutes
[Temperature and centrifuging radius] button repeatedly until
4. Press the
the desired parameter is displayed and the input field is reverse high-
lighted.
5. Use the [Rotary knob] to set the desired value.
'Start' button.
6. Press the
�� The settings are stored.
'*** OK***' is displayed briefly.
Program linking is only possible with programs where
ramp-up and brake levels are set.
The programs must be saved in the desired order before
linking, by means of either program entry or program
retrieval.
The program locations must be consecutive (e.g. program
locations 10+11+12).
1. Use the [PROG] button to select the 'PROG no.' parameter. The input
field is reverse highlighted.
[Rotary knob] to set the program location of the initial pro-
2. Use the
gram (XX+).
[RCL] button.
3. Press the
�� The centrifugation data of the desired program location is dis-
played
[PROG] button twice.
4. Press the
�� Parameter PR-PART is selected.
The input field is reverse highlighted.
Rev.: 20 / 01.2024
[t] button.
Software operation
39 / 50