Publicité
Les langues disponibles
Les langues disponibles
To Assemble The Creaming
Beater
Refer to Illustrations
Fitting The Wiper Blade
The wiper blade is supplied already
fitted and should always be removed
before cleaning.
1
Carefully fit the flexible wiper blade
onto the tool by locating the base
of the wiper blade into the slot then
fit one side into the groove before
gently hooking the end in place.
Repeat with the other side.
To Use Your Bowl Bright™
(In-Bowl Illumination)
Your Stand Mixer is fitted with an in-
bowl illumination feature located on
the underside of the mixer head.
To turn the in bowl illumination
OFF/ON, select BowlBright in the
settings menu and select OFF/ON.
To Fit And Use Your
Splashguard
Refer to Illustrations
Note: The splashguard is suitable for use
with the 7L bowl only.
To assemble
The splashguard assembly consists of
2 pieces: the head shield
splashguard
.
The splashguard cannot be fitted to the
bowl unless the shield is fitted.
1
Raise the mixer head until it locks.
2
Clip the head shield upwards onto
the underside of the mixer head until
fully located.
3
Fit the bowl onto the base.
4
Lower the mixer head.
5
Rest the splashguard on the bowl
rim and then slide forward until fully
located.
P
R
–
S
T
–
and the
During mixing, ingredients can be
added directly to the bowl via the
feed chute.
6
To remove the splashguard simply
slide it away from the mixer bowl.
7
To remove the head shield, raise the
mixer head until it locks. Remove the
tool if fitted, then pull the head shield
downwards from the underside of
the mixer head.
Note: Only fit or remove the splashguard
when the mixer head is in the locked
position.
We recommend that the head shield is
removed regularly from the mixer head
for cleaning.
Tool Adjustment
Refer to Illustration
K-beater, Whisk and Creaming Beater
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable sized spanner:
TYPE KWL90 = 19mm
Then follow the instructions below:
1
Unplug the appliance.
2
Raise the mixer head and insert the
whisk or beater.
3
Lower the mixer head. If the
clearance needs to be adjusted,
raise the mixer head and remove the
tool. Ideally the whisk and K-beater
should be almost touching the
bottom of the bowl.
Creaming Beater - Ideally it should
be in contact with the bowl surface
so that it gently wipes the bowl
during mixing.
4
Using a suitable spanner loosen the
nut sufficiently to allow adjustment
of the shaft. To lower the tool closer
to the bottom of the bowl, turn the
shaft anti-clockwise. To raise the tool
away from the bottom of the bowl
turn the shaft clockwise.
12
U
Publicité
