Yale BATTERY STAR Notice D'instructions page 8

Figure 2. Hoist Features
1 Limit Switches
2 Brake Dust Caps
3 Swivel Hook
4 Chain Stop Bumper
5
Battery Compartment
BATTERIES AND CHARGERS
1. Only use MILWAUKEE M18 batteries and chargers with this
hoist.
– 12.0 Ah battery is recommended for best performance.
The table below contains estimates of amount of lift at different
load capacities. Note that these are estimates and actual
performance will depend on the battery pack state of health.
Table 1. Batteries and Chargers
Load
Battery
(Tonne)
1/4
1/2
12.0 Ah
3/4
1
* Estimated total travel with equal lifting and lowering
2. Refer to the MILWAUKEE M18 battery and charger instructions/
manuals for operational instructions and safety information.
BatteryStar
TM
6 Chain Stop
7 Chain Bag
8 Coin Cell Battery Door
9 Hoist End Cap
* *
Hook Hook
Load
travel travel
(kg)
[ft] [m]
250 480 146
500 300 91
750 220 67
1000 180 55
REMOTE CONTROL
6
5
4
3
Figure 3. Remote Control
1
Power LED Indicator
2 Power Button
3
Directional Button DOWN
Power ON
To power the Remote Control ON:
1. Release the STOP Button (6) in case it is locked.
2. Push and release the Power Button (2).
Remote Control searching for Hoist:
– Power LED Indicator (1) intermediately flashes
green
Remote Control and Hoist are linked:
– Power LED Indicator (1) is solid green
– Hoist buzzer sounds for 3 seconds
Connection Error
– Power LED Indicator (1) quickly flashes green for
4 seconds
– Remote Control turns OFF
Power OFF
To power the Remote Control OFF:
1. Push and release Power Button (2).
– Power LED Indicator (1) turns OFF
– Remote Control powers OFF
– Hoist remains ON and goes to sleep after
30 minutes
Auto-OFF
5 minutes after non-use:
– Remote Control powers OFF
Lift or Lower Hoist Load
To lift the hoist load, press and hold the
Directional Button UP (4).
8
1
2
4
Directional Button UP
5 LED Indicator Screen
6
STOP Button
P/N: 192097707YLEM June 2024