Leica MATEO TL Instructions D'utilisation page 7

Safety Notes
In order to maintain the microscope in its original condition and to
ensure safe operation, you must follow the instructions and warnings
contained in this manual.
Only operate the system in a technically perfect condition.
General Safety
The instrument and accessories described in this manual have
been tested for safety and potential hazards. The responsible Leica
affiliate or the main plant must be consulted whenever the device is
altered, modified or used in conjunction with non-Leica components
that are outside of the scope of this manual.
Unauthorized alterations to the device or noncompliant use
shall void all rights to any warranty claims and product liability!
Prior to connecting power or to operation, check the
components and accessories for damage.
Do not use damaged, non-functioning components or
accessories. Instead, notify your Leica branch office or Leica dealer.
In order to ensure the product reliability and warranty services,
the system must be exclusively operated with the original accessories
and in particular the original power cord. The user bears the risk when
using non-approved accessories.
MATEO TL Microscope User Manual
Unauthorized alterations to the device or noncompliant use
shall void all rights to any warranty claims and product liability!
This instrument is for indoor use only.
In case of safety-related malfunctions, switch off the system
immediately, disconnect it from the power supply and take suitable
measures to prevent further use.
In all cases of doubt regarding the safety of the system, switch
off the system and prevent further use.
The internal battery has a durability of approx.5 years and can
be replaced in the factory or by a certified service technician.
The product should be positioned to ease the plug and unplug
of power cord by the operator.
Only insert or unplug data and control circuits when the
instrument is switched off, otherwise the instrument may be damaged.
The external USB devices associated with the equipment should
comply with IEC60950.
During the operation, necessary protective measures should be
taken by the customer to prevent injury to operator by the solution.
IMPORTANT! Mateo TL should not be subjected to UV
sterilization. UV degrades many materials, including plastic. Damage
from UV exposure is not covered under the manufacturer's warranty.
Important Notes 4