Publicité
Les langues disponibles
Les langues disponibles
Installing Optional
Objectives
For supported objectives, please refer
to "Technical Data" on page 61.
Caution:
If necessary, first lower the focus to prevent
damaging the objective front lenses.
1. Remove the screw caps on the nosepiece.
MATEO TL Microscope User Manual
2. Turn the knurled ring of the nosepiece to
make the target opening present at the
right of the nosepiece.
3. Align the objective's lower end with
thread to the target opening of the
nosepiece, turn the objective clockwise
until you cannot turn it anymore.
If possible, avoid touching the lens
surfaces of the objectives. If fingerprints do
appear on the glass surfaces, remove them
with a soft leather or linen cloth. Even small
traces of finger perspiration may damage
the surfaces in a short time. Refer to "Care
and Maintenance" on page 58 for additional
instructions.
If any nosepiece opening is left
unused, cover it with screw cap to protect the
microscope optics against dust.
4. In the live view, click
to open the
system "Settings" menu. Then, click
"Objective setting'' to set the parameters
for the newly installed objective. (For
details, please refer to "Objective Setting"
on page 25).
Preparation
Installing WIFI Dongle
Wi-Fi dongle is an optional item
With a Wi-Fi dongle, you can share images
using your smart device. For installation and
usage instructions, please refer to "Sharing
Image(s) via Your Smart Device through Wi-
Fi" on page 40.
Confluency module
Confluency module is an optional item,
please purchase separately if needed.
For the activation and usage of confluency
module, please refer to "Confluency Check"
on page 42.
Transportation Case
All components of Mateo TL can be put
into a transportation case for their safe
transportation.
23
Publicité
