Submenu "System - Sygonix 2300294 Notice D'emploi

g) Submenu "System"
This submenu enables to select/display various setting functions and system information with the "
Press the " " button (6, 19) to confirm your selection. You can then change the settings as usual with the "
" " button and confirm with the "
The submenu offers the following functions:
• Enable/disable button confirmation tone
This setting is not available as the monitor/DVR has no built-in speaker in this product version.
• Set date/time
Use this menu to set the date and the time. These data can be displayed both in the video image (can be enable/dis-
abled) and in the file name. Check the time occasionally. In addition, the summer/winter time must be set manually.
• Reformat SD memory card
A newly purchased memory card usually comes pre-formatted and should pose no problems when used in the
monitor/DVR. If no recordings can be created or saved, reformat the memory card. Please note: All existing data on
the memory card will be permanently lost after formatting!
• Reset settings to factory defaults
Here you can reset all settings to factory defaults if necessary.
• Display information about the SD memory card used
The display shows the occupied space on the used memory card or the memory card size (for example:
20.2 GB/29.7 GB = 20.2 GB are already used, 29.7 GB are a memory capacity of a 32 GB memory card).
There are two different methods for calculating the memory capacity.
1) 1 kByte = 1024 bytes (binary = 2^10). 1 MByte = 1024*1024 = 1048576 bytes (binary = 2^20) etc.
2) 1 kByte = 1000 bytes, 1 MByte = 1000000 bytes etc.
Memory card manufacturers use method 2, but the monitor/DVR manufacturer uses method 1. For this
reason, a 32 GB memory card inserted in the monitor/DVR is displayed as 29.7 GB. You can also notice
these differences in the computer operating systems/data carriers.
• Motion Detection
Off, Low, Middle, High
• Display firmware version
This display shows information about the current firmware version.
40
" button (6, 19).
" or " " button.
" or