Assembly Of The Darts; Attaching The Feet; Designation And Function Of Each Of The Parts; Operation Of The Dartboard - Crivit 338489 2001 Notice D'utilisation

The cross in the middle of the drill tem-
plate marks the height of the bullseye on
the dartboard. Afterwards, mount the
dartboard with the screws and dowels
included.
Assembly of the darts (Fig. D)
Screw the tips and the shaft to the grip, as
shown, and insert the wings into the cross-slits.
Note: Please ensure that the tip is screwed
in tightly to the flat side of the barrel.
Attaching the feet (Fig. E)
You can also set up the dartboard without
wall mounting, on a suitable horizontal sur-
face, using the two feet (14). The two feet
(14) are on the back of the dartboard.
Please note that setting up the dartboard in
this way can affect play. When the dart-
board is set up on a horizontal surface, it is
tilted and can't be optimally positioned.
1. Remove the feet (14) from the holder on
the back of the dartboard.
2. Attach the feet (14) to the back of the
dartboard as shown in Fig. E.
Designation and function of
each of the parts (Fig. A and C)
Single: Number of points as shown
1
Double: Number of points x 2
2
Triple: Number of points x 3
3
Bull: Outer ring counts for 25 points;
4
Bullseye counts for 50 points
Catching border: Border, no points
5
Loud-speaker
6
Connection point for power adaptor
7
4 LED displays
8

Functional buttons

9
Play list
10
Dart holder
11
Drill holes
12
Mounting bracket (back)
13

Operation of the dartboard

Turning the product on and off

The product is fitted with an automatic
switch-off system. To switch the product
on, connect the power adaptor with the
dartboard and mains power point. If the
product is not used for more than 10 min-
utes, displays and systems are automatically
switched off (standby mode). As long as the
power adaptor is plugged in, the product
will "remember" the current score. Via the
pressing of any function button, the product
will switch itself on again.
To switch of the product completely, unplug
it at the mains.
Functional buttons (Fig. A)
POWER
Press the POWER button to switch the prod-
uct on and off.
GAME
Press the GAME button to select a game.
The displays will show the game number,
above left, the name of the game, above
right, below left, the game options are
shown, and below right, the number of
players.
Note: While the game is running, press
GAME once to stop the game and restart.
SELECT
Press the SELECT button to select options for
all players within the current game.
Note: Abbreviations for the various op-
tions are shown below left on the display.
GB/IE 25