Precor Discovery Série Manuel De L'utilisateur page 61

Threading the Cable Through the Top Frame of the
Weight Tower
The cable passes through an opening in the top of the weight tower frame,
over the pulleys and then back down through the frame to the weight stack.
Use the following procedure to remove both cable retainers and the pulley that
covers the opening where the cable passes upward through the frame.
Figure 13: Position of cable over pulleys
Seated Calf Extension Assembly Guide: Routing the Cable Assembly
To route the cable through the weight tower:
1. Locate the pulley positioned over the opening where the cable will thread
up through the weight tower. Using a ³ ₄-inch socket wrench and a ³ ₄-inch
open-end wrench, remove the bolt, and then remove the pulley and cable
retainer.
Figure 14: Removal of pulley and cable retainer
11