Precor Discovery Série Manuel De L'utilisateur page 63

5. Thread the cable down through the opening under the second pulley, as
shown in the following figure.
Figure 17: Cable route down through weight tower frame
Seated Calf Extension Assembly Guide: Routing the Cable Assembly
6. Guide the cable down to the weight stack. Remove and discard the
temporary bolt threaded into the selector stem on the weight stack.
7. Insert the cable bolt into the stem and thread it at least 7 threads (turns).
The distance from the underside of the bolt head to the top of the weight
selector stem should be no more than 1¹ ₄-inch (32 mm).
Important: Make sure at least seven (7) threads on the cable bolt extend into
the selector stem.
Figure 18: Cable attachment into weight stack
13