Main Menu Mixer G; Mixer: V-Tail; Mixer: Combiswitch - Multiplex ROYALevo 7 Manuel D'utilisation

ROYAL evo 7

Main menu Mixer G

15.
In the main menu Mixer you can set up all the mixers
required for your model. The Mixer main menu is a
dynamic menu, i.e. in the interests of clarity only those
mixers are shown which are used in the current model.
Fixed-wing models
The mixers V-tail, CombiSwitch and Ail.Diff (ai-
leron differential) are always present.
The following mixers may also appear, depending on
the model template you have selected:
ELEVATR+, V-tail+, DELTA+, AILERON+, FLAP+
For a model based on the ACRO model template the
Mixer main menu may look like this:
Model helicopters
Helicopters always feature the TAIL mixer (static tail
rotor compensation). For helicopters with electronic
swashplate mixing (CCPM) the Rotor head mixer also
appears when the HELIccpm model template is in use.
Fixed-wing models and helicopters
If free mixers are required for additional mixed func-
tions, they may be defined in the Setup / MixerAB
menu for both fixed-wing models and helicopters (
13.2.). These free mixers can also be set up in the Mixer
main menu, where they appear as MixerA and Mix-
erB (Fig. 1).
Fig. 1 Fig. 2

15.1. Mixer: V-tail

for fixed-wing models only
Adjust. range ON, OFF
If your model has a V-tail, switch the V-tail mixer ON.
The Mixer main menu now automatically includes the
mixer V-TAIL+. If the mixer ELEVATR+ was already
present, it is now replaced by V-TAIL+.
In the "Servo Assignment List" (
Rudder and Elevator or ELEVATR+ are replaced by
V-TAIL+.
If you switch off the V-tail mixer again, the previous
state is restored.
Direction of rotation and travel for the mixer inputs are
adjusted in the V-TAIL+ mixer.

15.2. Mixer: CombiSwitch

I Aileron
rudder (aileron is Master) 2% to 200 %
Aileron rudder (rudder is Master) -2% to -200%
2% increments, switchable
fixed-wing models only
2% to 200 %
Aileron
Adjust. range
-2% to -200%
Aileron
Switch CS/DTC (<N)
"Following" value can be assigned to
F
a 3D digi-adjustor
(
Smooth, constant turns can only be achieved with co-
ordinated use of ailerons and rudder - this applies to
full-size aircraft and models alike. This is not easy, espe-
cially for the inexperienced pilot. The combi-switch
couples the ailerons and rudder, making it simpler to
perform turns when making the transition from simple
rudder-elevator models to the more demanding "full-
house" model aircraft (aileron / elevator / rudder).
If you wish, the CombiSwitch mixer can be switched
on (= 1) or off (= 0) at any time using the switch
"CS/DTC" (<N). The arrow
the combi-switch is ON at the "down" position. If the
switch is at the ON position, this is indicated by an aster-
isk ( ) after the arrow.
Page 36
16.2.) the servos
Rudder (aileron is Master)
rudder (rudder is Master)
11.2.2.)
on the screen indicates that