Adjusting And Replacing The Stick Tops; Using The System For The First Time; Charging The Transmitter Battery; Switching On For The First Time - Multiplex ROYALevo 7 Manuel D'utilisation

Masquer les pouces Voir aussi pour ROYALevo 7:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Fig. 1
Fig. 2
9.5.8.

Adjusting and replacing the stick tops

The ROYALevo is supplied as standard with three pairs
of stick tops of different length. They are easy to
change, rotate and adjust for length:
1.
Lay the transmitter on a flat surface;
2.
Grasp the stick top in one hand (Fig. 1);
3.
Undo the retaining nut with your other hand by
twisting it clockwise (Fig. 1).
The stick shaft is smooth, and the stick top can now be
rotated or adjusted in length. If you wish to swap the
stick tops, unscrew the retaining nuts from both stick
tops and use them to secure the replacements (Fig. 2).
Before fitting the stick tops ensure that the stick shafts
are clean and free of grease and oil. If you neglect this,
the stick tops may not stay "put" on the shafts.
Fig. 1
Fig. 2
ROYAL evo 7 - Instructions
10.
Using the system
for the first time
10.1.

Charging the transmitter battery

The ROYALevo transmitter is supplied with a part-
charged battery, and it must be given a full charge be-
fore being used for the first time. Please read the charg-
ing notes carefully to avoid damaging the transmitter
battery or the transmitter (
10.2.

Switching on for the first time

When you switch on for the first time you will see the
following screen display:
Use the "L " (UP) und "M " (DOWN) buttons to select
your preferred language, and press the "ENTER" button
to confirm your selection.
10.3.

Switching on

Every time you switch the transmitter ON the power-on
info display always appears briefly. This shows informa-
tion on the transmitter type, the software version and
the current national language you have selected for the
screen text displays:
If there is no RF module installed, the following message
will appear briefly:
"Attention: no RF!"
The first time you switch on, status display 1 appears;
subsequently you will see the status display 1 - 3 that
you last used:
Picture: status display 1
Page 17
8.).

Publicité

Table des Matières
loading

Table des Matières