Multiplex ROYALevo 7 Manuel D'utilisation page 279

ROYAL evo 7
The timer can be used in two different modes:
1. Set the alarm to 0:00:00
The timer starts at zero, runs upward, counts the
time cumulatively, and is stopped and re-started by
the switch assigned to it. There is no alarm when
the timer is used in this way.
2. Set the alarm to a time other than 0:00:00
The timer starts at the set alarm time, runs down-
ward and triggers an alarm when the selected time
has elapsed.
Alarm pattern:
at the end of each full minute:
short double beep (
from 5 seconds before the set alarm time:
short double beep at one-second intervals (
when the alarm time is reached
long double beep ( ---
Line 3: Difference (display only)
Here the screen displays the time which is also shown in
status display 2. It is the difference between the time
and the alarm. The arrow preceding the difference indi-
cates the direction of running of the timer:
'
running upward
#
running downward
The difference runs downward until the alarm time is
reached, and upward if the alarm time is reached or ex-
ceeded. The preceding arrow indicates upward or
downward.
Line 4: Switch
At this point you can select the transmitter control
which you wish to use to start and stop the timer. You
can select any control apart from the aileron, rudder
and elevator sticks.
Press the ENTER button or a 3D digi-adjustor to open
the input field. The following display then appears:
The transmitter control which you now select to operate
the timer will operate the timer in all models which use
the same assignment (
If you now press the ENTER button to confirm your ac-
tion, you can assign the desired transmitter control as
the "Timer Switch" simply by operating it. We call this
process QUICK SELECT.
Leave the transmitter control at the end-point at which
the timer is to run. Close the input field by pressing the
ENTER button or one of the 3D digi-adjustors.
)
)
---)
18.6.).
Special case: "H / THR-CUT" and "M / TEACHER" but-
tons:
There are two modes of operation involving the "H" and
"M" buttons. The mode is activated according to the
method which you use to leave the "Switch" field when
assigning the timer switch:
1. Toggle " ... ":
Press button = timer runs
Press button again = timer stops
2. Latch " „ ":
Button pressed = timer runs
Button not pressed = timer stops
The switch you have selected to control the timer (in
our example: F) and the position of the ON state (in our
example: ' = forward) are displayed in line 4. If the
switch is at the "Timer ON position", an asterisk '* ap-
pears after the arrow. The control for the switch is also
shown in status display 2 after the timer time:
Page 48