Touch Display/Main Menu - Multiplex Cockpit SX 7 Mode D'emploi

8. Touch display/main menu

To switch on: Activate the transmitter by briefly pressing the
on/off button.
This opens the timer display. (If you have activated the throt-
tle check, you will receive a corresponding warning signal and
will then be sent directly to the main menu).
The timer menu displays
T1 - the motor run time
T2 - the operating time
To reach the telemetry display and the transmitter data,
"swipe" left or right with your finger.
Use the double arrow to close the menu.
The orange bar which is now displayed at the top looks like
this:
· Model memory with model name
· Position in the menu
· Time
· The double arrow opens the timer menu
· Telemetry output status symbols:
Sound off Vario tone
output of the telemetry
The status can also be changed using the button on the left
side (teacher/vario).
· Battery status display
Nine symbols appear in the display at the bottom:
Announcement Alternating
telemetry data
data and vario tone
output
1. Memory card symbol: The model memory
Here you can select an existing model saved in
one of the 200 memory spaces or configure a new
model (see section 7).
2. Transmitter symbol: Setting the transmitter
a. Under basic settings, the language (D, GB, F) of
the battery alarm and the throttle mode (throttle left
or right) can be selected
b. M-Link settings pertains to the binding, range and failsafe tests
c. the following is possible under System settings:
- Touch calibration
- Setting the time
- Performing updates
- Resetting to factory settings
3. Plane symbol: Model-specific settings
Here you can change the settings for the model:
- Model type (Easy, Acro, glider, Delta, tail type,
number of flaps)
- You can change special model settings (such as
flight phases, throttle, throttle check, M-Link)
4. Stick symbol: Transmitter settings
a. Control settings, such as dual rate, expo
b. Control assignment modes 1 to 4
c. Control calibration
5. Sigma symbol: Mixer
Here's where you'll find the various setting op-
tions of the mixer (see section 7.9).
6. Servo symbol: Servo programming
Hint: Set mechanically first
Before you change (electronic) settings on the
transmitter, make sure the mechanics on the mo-
del are set as optimally as possible.
· Affix the output arm at right angles to the pushrods on the
servo output. This will avoid mechanical differentiation.
· Set the desired neutral position of the ailerons as well as
possible by changing the length of the pushrod.
· Mount the pushrods as far inside as possible and use the
maximum servo travel. This reduces the effect of gear back-
lash and makes optimal use of the servo's power
· Mount the aileron pushods on the horn as far outside as
possible. This reduces the effect of play in the pushrods and
transfers the servo's power to the aileron optimally.

29