Annex; 11.1 Compliance With Eu Directives; 11.2 Checklist For The Manufacturer - SICK MOC3ZA Notice D'instructions

Operating instructions
MOC3ZA
11

Annex

Checklist for the manufacturer/installer for the installation of standstill monitors
Details about the points listed below must be present at least during initial commissioning — they are, however, dependent on the
respective application, the specifications of which are to be controlled by the manufacturer/installer.
This checklist should be retained and kept with the machine documentation to serve as reference during recurring tests.
1. Have the safety rules and regulations been observed in compliance with the directives/standards applicable
to the machine?
2. Are the applied directives and standards listed in the declaration of conformity?
3. Does the protective device comply with the required PL/SIL claim limit and PFHd in accordance with
EN ISO 13849-1/EN 62061 and the required type in accordance with IEC 61496-1?
4. Have measures been taken to prevent the unintentional starting of the drive or the machine after the
detection of standstill?
5. Has the maximum stopping and/or stopping/run-down time of the machine been measured, specified and
documented (at the machine and/or in the machine documentation)?
6. Are the required protective measures against electric shock in effect (protection class)?
7. Is the entire wiring designed in accordance with the required PL/SILCL as per EN ISO 13849-1/EN 62061
and does the design of the wiring comply with the circuit diagrams?
8. Has the protective function been checked in compliance with the test notes of this documentation?
This checklist does not replace the initial commissioning, nor the regular inspection by qualified safety personnel.
8014608/1DS0/2022-02-16
Subject to change without notice
Annex

11.1 Compliance with EU directives

EU declaration of conformity (excerpt)
The undersigned, representing the following manufacturer herewith declares that the
product is in conformity with the provisions of the following EU directive(s) (including all
applicable amendments), and that the respective standards and/or technical
specifications are taken as the basis.
Complete EU declaration of conformity for download: www.sick.com

11.2 Checklist for the manufacturer


© SICK AG • Industrial Safety Systems • Germany • All rights reserved
en
Chapter 11
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
79