Starlet 50
3.3 Assembling the Hiller rotor
Assemble the rocker 4618.27 as shown in the drawing. Note that the hole in the pivot bar
4618.28 must line up with the through-hole in the rocker, to ensure that the flybar can be slid
through later without jamming or binding. Fit an M2 x 4 screw on the outside on each side to fix
the two ballraces to the hub. Check that the rocker rotates freely.
Press the ballraces 4618.6 into both sides of the rocker 4618.27. Slide the flybar 4718.67
through the rocker and set it exactly central, i.e. projecting out of the bearings by an equal
distance on both sides.
26