GRAUPNER heim Starlet 50 Mode D'emploi page 71

Starlet 50
Connect the carburettor arm to the throttle servo output arm using this pushrod, as shown in the
drawings:
2.2 Installing the remaining radio control system components
To attach the gyro system to the gyro platform we recommend the use of double-sided foam
tape, e.g. Order No. 742. The cables should be grouped with the servo leads and routed
forward along the side of the mechanics to the receiver.
Pack the receiver battery in foam rubber, with the receiver above it, and stow these components
in the RC box, where they are secured with rubber bands. Note that the receiver sockets should
be on the right-hand side, so that the servo cables can be plugged in directly, without the need
for extension leads.
Bundle the cables together with spiral tubing, and attach them to the mechanics using cable
ties. It is important that the wires are not under stress, make no contact with rotating parts, and
do not rub or chafe against any sharp edges or corners.
Install the receiving system switch on the switch console, which is screwed to the right-hand
side of the sub-structure. Connect the switch to the battery and receiver in the usual way.
23