Installation/Mechanical Connection - SICK PAC50 Notice D'instruction

Operating Instructions

5 Installation/Mechanical connection

Ensure that there is no mechanical load on the pressure switch during installation. Please
observe the ambient conditions specified in Section 9 (Technical data). The pressure transmitter
must not be exposed to condensation.
5.1 Installation on a mounting rail
The PAC50 pressure switch has an integrated fixing mechanism for installing on a mounting rail according to
DIN EN 60715 – 35 mm x 15 mm / 7.5 mm.
To install the PAC50, position the lower fixing guide on the mounting rail (see Figure 7
•
PAC50 up until it locks into place (see Figure 7 2 and 3).
To remove the PAC50 from the mounting rail, pull the fixing clip down and tilt the PAC50 up and away from
•
the mounting rail.
1
Figure 8: Installation on a mounting rail
7 8 O p e r a t i n g I n s t r u c t i o n s | S I C K
Installation/Mechanical connection
2
3
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
PAC50
) and tilt the
1