SICK PAC50 Notice D'instruction page 71

Operating Instructions
P = pressure
p =p
supply 0
p
1
p
p
2
t
0
Timer A
= stored parameters
Figure 6: Leakage measurement schematic diagram
4.3.2 Starting the leakage measurement
After connecting the sensor to a voltage source that meets the specifications, the sensor starts and initially
shows the initialization "SICK PAC50-LT" and the corresponding firmware version "FWv x.xx" on the display.
It then immediately switches to Leakage Tester mode. The display indicates the system pressure currently
applied p as well as "Wait" and "User" in the bottom two lines. Everything is displayed in green here.
0
By pressing the pushbutton in the middle for slightly longer (> 200 ms), the measurement starts with the
preset parameters.
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
t
1
t
= adjustable parameters
Product description
p
end
t [sec]
t
2
t
out
= output value
V=volume
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
7 1