SICK PAC50 Notice D'instruction page 89

Operating Instructions
The info mode can be aborted by simultaneously pressing the
pushbutton in the middle.
7.4 Programming mode
7.4.1 Setting the device parameters
To switch to programming mode, the
programming mode is inactive for a long period (> 15 seconds), the device automatically reverts back
to display mode. The measuring and switching functions continue to run (in the background) while the
device is in programming mode.
Selection:
The parameter/menu item to be set should be selected first using the
•
in display area B: "SET" is helpful in this regard.
To select the parameter/menu item to be set, press the
•
Making settings:
The parameter value to be set is displayed in display area A. Display areas C1/2 and E1/2 display the
•
existing parameter value settings.
The parameter is set using the
•
The setting becomes active the moment a selected parameter value is confirmed by pressing the
•
pushbutton, even if the pressure switch is still in programming mode.
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
Operation and parameter settings
pushbutton must be pressed for longer than 2 seconds. If the
and pushbuttons and then confirmed with the
and pushbuttons or by pressing the
and pushbuttons. The note
pushbutton in the middle.
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
pushbutton.
8 9