Operating Instructions
2.3 General safety notes and protective measures
The device is only to be used if it is in perfect working order.
2.3.1 Electrical installation work
Only authorized personnel are allowed to perform the electrical installation work
•
Electrical connections between the PAC50 and other devices may only be made and separated when
•
there is no power to the system
Only operate within the specified voltage range
•
Only operate with the loads specified in these operating instructions
•
Do not use damaged cables (risk of short-circuiting or water ingress via the cable/male connector)
•
Select and implement wire cross-sections and their correct fuse protection in accordance with the applica-
•
ble standards
Check the assembly is correct and that the connecting cable is positioned appropriately
•
Do not open the housing
•
Observe the standard safety requirements when working on electrical systems
•
2.3.2 Mechanical connection, pressure connection
Only authorized personnel are permitted to perform the assembly work
•
Only operate within the specified pressure range
•
Only use the accessories provided
•
Do not open, modify, or extend the product
•
Check that assembly has been carried out correctly and that the pressure connections/tubes are
•
positioned appropriately
Do not use seals that are damaged (replace them)
•
Do not install the seal using tools or pointed/sharp objects
•
Do not carry out assembly/disassembly while the system is under pressure
•
Do not subject the device to mechanical stress or attach it under mechanical tension
•
Make sure that no mechanical tension is caused by the pressure connection and electrical connection
•
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
Safety
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
6 3