Errors - SICK PAC50 Notice D'instruction

Operating Instructions

8 Errors

8.1 Errors and warning messages (indicator flashes in display segments A and B, Table 5)
Indicator A Indicator B
OL OVERPRESS
UL UNDERPRES
ERR1 GEN.ERROR
ERR2 SHORTOUT1
SHORTOUT2
ERR3 OVERVOLTG
ERR4 LOW VOLTG
ATT1 SHIFT RP1
SHIFT RP2
ATT2 ADJ>LIMIT
KEYLOCKED
LOCK
Table 7: Errors and warning messages
9 8 O p e r a t i n g I n s t r u c t i o n s | S I C K
Status Description
Error Applied pressure > upper limit of measuring range
Error Applied pressure < lower limit of measuring range
Error General error
Error Short-circuit at one of the two outputs
Error Applied supply voltage > 30 V DC
Error Applied supply voltage < 17 V DC
Warning Switching point setting made by the operator below
the reset point that is set. The reset point is auto-
matically set below the new switching point with the
smallest possible hysteresis.
Warning Displayed if the applied pressure during zero
balancing lies outside the permitted limit of 5% of
the range
Warning Displayed if an attempt is made to access the
programming mode while the input lock is active
Errors
Action required
Set pressure to within
measuring range
Set pressure to within
measuring range
Contact SICK
Remove the short-circuit
Make the correct setting for
the supply voltage
Make the correct setting for
the supply voltage
Acknowledge by pressing the
<enter> pushbutton
Acknowledge by pressing the
<enter> pushbutton
Enter the password or unlock
via IO-Link if parameter entry
has been locked by IO-Link
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
PAC50