SICK PAC50 Notice D'instruction page 84

Operating Instructions Installation/Mechanical connection PAC50
Figure 14: Plug connection for 4 mm pneumatic hose (push-in fitting, PIF)
5.6 Process connection via ¼ NPT female thread adapter (Figure 15)
The sensor is supplied with a pre-mounted adapter on the bottom of the device. The adapter has a G ¼"
male thread, which is mounted on the bottom of the sensor with a max. torque of 0.8 Nm, and which can be
screwed back in if it has been removed. The adapter has a connection with a ¼" NPT female thread on the
process side. Make sure that the maximum tightening torque of 0.8 Nm on the bottom of the sensor is not
exceeded during mounting on the process side. This can lead to the destruction of the device.
8 4 O p e r a t i n g I n s t r u c t i o n s | S I C K 8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice