SICK PAC50 Notice D'instruction page 76

Operating Instructions
Measurement Indication of the
mode applied pressure
Programming Value of the selected
mode parameter
Table 3: Indicators in display areas for LT mode
Once the set switching points (SP1/2, RP1/2, FH1/2, or FL1/2) have been reached, the color of the respec-
tive switching point display areas changes between green and red.
The color change can be set using the "DISC" function:
Red if the switching point is not reached or undershot, or if the applied pressure is within the defined
•
window, and green if the switching point is exceeded or if the applied pressure is outside the window
("DISC" function: OD)
Red if the switching point is exceeded or if the applied pressure is outside the defined window, and green
•
if the switching point is not reached or undershot, or if the applied pressure is within the window ("DISC"
function: DU)
Always red (no color change, "DISC" function: RED)
•
Always green (no color change, "DISC" function: GRN)
•
7 6 O p e r a t i n g I n s t r u c t i o n s | S I C K
Product description
Set pressure unit C1: status of the
leakage measure-
ment (Wait User,
MEAS DONE) or
TimA until P1 is
reached, error
message ("WARN")
if the supply pres-
sure is not sufficient,
"DONE" once the
measurement has
been completed
(without errors)
C2: QL, dT, dP
alternately
or P>P1 until P1 is
reached or P<P2
until P2 is reached
Selected parameter
D2: "Leakage E1: timer in seconds
measurement until P1 is reached
activation" status E2: measured
values for QL, dT, dP
8017612/14NK / 8/2/2019 | PAC50
Subject to change without notice
PAC50