GRAUPNER heim UNI-Mechanik 2000 Mode D'emploi page 77

UNI-Mechanics 2000
Apply thread-lock fluid to the sockets in the flybar paddles 4682.34, and screw them onto the
ends of the flybar to a depth of exactly 15 mm. Set them exactly parallel to each other and to the
control bridge.
Remove the temporary screws from the top section of the rocker, and fix the rotor brake plate
1289 to the rocker using four M2 x 16 screws.
Apply thread-lock fluid to the two guide pins 4450.44 for the collective pitch compensator, and
press them into the rotor head centre piece.
3.4 Installing the main rotor head
(bag U2-10E)
Place the main rotor head on the main rotor shaft, and line up the hole in the rotor head with the
upper cross-hole in the main rotor shaft. Insert the special screw 4448.87 and tighten it to
secure the rotor head. The pushrods 4618.150 and 4618.151 are made up and installed as
shown in the drawing.
Make up two straight and two angled pushrods as shown in the drawing.
31