GRAUPNER heim UNI-Mechanik 2000 Mode D'emploi page 73

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UNI-Mechanics 2000
Make up the throttle pushrod from one threaded rod 4445.84 (2 mm Ø, 45 mm long) and two
ball-links 4618.55 as shown in the illustration; the stated dimension refers to the free space
between the ball-links.
Use this pushrod to connect the carburettor arm to the servo output arm as shown in the
illustration:
2.2 Installing the remaining radio control system components
To attach the gyro system to the gyro platform we recommend the use of double-sided foam
tape, e.g. Order No. 742. Run the cables forward along the side of the mechanics to the
receiver, together with the servo leads.
Pack the receiver battery in soft foam, such as the foam sleeve, Order No. 1637, then mount it
on the battery console and secure it with two cable ties.
The receiver, gyro electronics and speed governor (if present) can be installed in the RC box.
Pack these items in soft foam and secure them by fitting the wire retainer bar.
Bundle together all the servo, gyro and battery leads, and wrap them in spiral tubing or fit cable
ties round them. Run the loom forward to the receiver and fix it to the side of the mechanics.
Attach the receiving system switch to the switch console mounted on the right-hand side of the
sub-structure, and connect it to the battery and receiver.
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

4448.ln

Table des Matières