Programming The Forced Opening Alarm; Programming Reset Cards - Sygonix SY-4500816 Notice D'emploi

p) Programming the forced opening alarm
If the lock controlled by the relay is forcibly opened, a continu-
ous alarm sounds via the buzzer and (if installed) the external
intrusion alarm. To stop the continuous alarm/intrusion alarm, the
opening button must be pressed indoors or a valid user PIN code
must be entered. If this does not happen, the opening alarm will
continue to sound until the preset warning duration has elapsed.
The forced opening alarm is configured at the same time as the
door open warning.
q) Programming reset cards
44
Enter the digits 62#0# to turn off this alarm
function. The alarm function is disabled by
default.
Enter the digits 62#1# to turn on this alarm
function.
Start your entry with the * key, followed by
the current master code (in this example,
the factory preset code "123456" is used).
Press the # key to confirm your entry. A long
beep/buzz indicates the switch. The red LED
flashes every 1.5 seconds to indicate that
programming mode is enabled.