Enable Programming Mode - Sygonix SY-4500816 Notice D'emploi

Create user ID and PIN
code
Configure user card
Delete user
Delete all users
b) Enable programming mode
Program the code lock at the installation location/before mounting
to reduce the installation time.
Important – if you have already programmed another
master code, use the new master code.
28
1<User ID>#<User PIN code>#<Re-
peat user PIN code>#
Create user card (Auto-ID).
1<Hold the card over the
on the keypad>
2<Enter user ID>#
2<Hold card over the
the keypad>
2<0000>#
Exit programming mode *
Enter the master code to enable program-
ming mode. Start your entry with the * key,
followed by the current master code (in this
example, the factory preset code "123456"
is used). Press the # key to confirm your
entry. A long beep/buzz indicates the switch.
The red LED flashes every 1.5 seconds to
indicate that programming mode is enabled.
symbol
symbol on