Sygonix SY-4500816 Notice D'emploi page 33

Present/read EM
card
Start your entry with the * key, followed by
the current master code (in this example,
the factory preset code "123456" is used).
Press the # key to confirm your entry. A long
beep/buzz indicates the switch. The red LED
flashes every 1.5 seconds to indicate that
programming mode is enabled.
Start with the number 1. Enter a visitor ID
(starting with zero) and press #. Next, enter
the number of possible uses. In the exam-
ple, the card becomes invalid after the lock
has been opened five times.
Then hold the EM card that you want to reg-
ister over the
confirm the programming of the visitor EM
card. You will hear a confirmation tone.
You can now set up additional visitor EM cards.
Start with the number 1. Enter a visitor ID
(starting with zero) and press #. Next, enter
the number of possible uses. In the exam-
ple, the card becomes invalid after the lock
has been opened five times. Press the #
button to exit the configuration process.
Assign a visitor PIN, press the # key and
repeat the visitor PIN to confirm. Confirm
the ID assignment with the # button. You will
hear a confirmation tone. You can now set
up additional visitor PINs in the same way
as described above. Press the * button to
exit the configuration process.
symbol on the keypad to
33