Configuring A New Master Code - Sygonix SY-4500816 Notice D'emploi

For security reasons, we strongly recommend that you
change the preset master code. For instructions on
how to change the master code, refer to "c) Configuring
a new master code". After changing the master code,
enter the new master code to enable programming
mode.
c) Configuring a new master code
The master code is saved to memory slot 0. The code must be
6 digits long.
If you have forgotten the existing master code, you can
choose a new code after resetting it to the factory de-
fault "123456". For details on how to reset the code,
refer to "r) Resetting to factory settings".
Enter the master code to enable program-
ming mode. Start your entry with the * key,
followed by the current master code (in this
example, the factory preset code "123456"
is used). Press the # key to confirm your
entry. A long beep/buzz indicates the switch.
The red LED flashes every 1.5 seconds
when the keypad is in programming mode.
Enter 0 and select your new master code,
e.g. 852491. Then press the # button and
repeat your master code again to confirm.
Then press the # key and complete your
entry with the * key.
29