Programming 125 Khz Em Cards For Regular Users - Sygonix SY-4500816 Notice D'emploi

e) Programming 125 kHz EM cards for regular
users
Program EM cards if you would like to enable access via EM
cards. The product uses its Auto ID function to automatically gen-
erate a user ID for the relevant EM card. You do not need to enter
these manually. You can register up to 500 EM cards using the
keypad. IDs from 0 to 499 are assigned automatically.
Alternatively, you can assign an EM card directly to a user ID.
Present card
Start your entry with the * key, followed by
the current master code (in this example,
the factory preset code "123456" is used).
Press the # key to confirm your entry. A long
beep/buzz indicates the switch. The red LED
flashes every 1.5 seconds to indicate that
programming mode is enabled.
Start with the number 1.
Then hold the EM card you want to register
over the symbol on the keypad.
The user ID and user PIN code are auto-
matically assigned by the product. The PIN
code is 1234.
Press the * button to exit the ID assignment.
31