Configuring The Buzzer - Sygonix SY-4500816 Notice D'emploi

n) Configuring the buzzer
The keypad and relay feature a built-in buzzer. You can switch the
buzzer on/off separately for both components. Both buzzers are
programmed via the keypad.
Keypad buzzer
1
The buzzer is enabled by default.
42
Start your entry with the * key, followed by
the current master code (in this example,
the factory preset code "123456" is used).
Press the # key to confirm your entry. A long
beep/buzz indicates the switch. The red LED
flashes every 1.5 seconds to indicate that
programming mode is enabled.
Enter the memory space 70. Then press
the # button. To turn off the keypad buzz-
er, press 0. Then press the # key to confirm
your entry.
Select the memory space 70. Then press
the # button. To turn on the keypad buzz-
er, press 1. Then press the # key to confirm
your entry.