Programming The Switching Code - Sygonix IP65 Mode D'emploi

i) Programming the Switching Code
The switching code permits permanently activating a relay (until the switching
code is entered again). Observe the above subchapter 8. h).
Observe that the code length of master code, user codes and switching
code must be the same. If you programme a 5-digit master code, your
switching code must have 5 digits as well.
Start the programming mode as described in chapter 8. a). The yellow LED
must be lit.
Then enter:
*54 BBBB
Example:
The old master code is programmed to "9999".
35