Sygonix SY-4500816 Notice D'emploi page 38

Warning! If 1 is entered for the timer setting, this
corresponds to a duration of 500 ms. The maximum
timer duration is 99 seconds (99 seconds = enter digits
"99").
In the factory settings, the timer is set to 5 seconds.
In toggle mode, the relay opens when the user PIN code is en-
tered. It does not close until a valid user PIN code is entered
again. The opening code does not have to be identical to the
closing code, but it must be valid!
38
Start your entry with the * key, followed by
the current master code (in this example,
the factory preset code "123456" is used).
Press the # key to confirm your entry. A long
beep/buzz indicates the switch. The red LED
flashes every 1.5 seconds to indicate that
programming mode is enabled.
Enter the number "4", and then enter the
duration (in seconds) for which you want to
keep the lock open. In the example, it is 6
x 1 s = 6 seconds. Then press the # key to
confirm your entry.
Enter the digit "4" and add "0" to switch to
toggle mode. Then press the # key to con-
firm your entry.
After you have configured the settings, press
the * button to exit programming mode.