Removing The Presser Foot; Attaching The Presser Foot; Adjustment Of Foot Pressure - ELNA eXtend 264 Livret D'instructions

1 mm
1 mm
1 mm

Removing the Presser Foot

1. Turn off the power switch and unplug the
z Turn off the power switch and unplug the machine.
1. Turn off the power switch and unplug the
machine.
1. Turn off the power switch and unplug the
x Raise the needle and the presser foot.
machine.
c Press the lever located on the back of the foot holder.
machine.
2. Raise the needle and the presser foot.
The presser foot will drop off.
2. Raise the needle and the presser foot.
2. Raise the needle and the presser foot.
3. Press the lever located on the back of the foot
q Needle
3. Press the lever located on the back of the foot
holder. The presser foot will drop off.
3. Press the lever located on the back of the foot
w Presser foot lifter
holder. The presser foot will drop off.
e Foot holder
holder. The presser foot will drop off.
Needle
r Lever
Needle
Presser foot lifter
Needle
Presser foot lifter
Foot holder Presser foot lifter
Foot holder
Lever Foot holder
Lever
Lever

Attaching the Presser Foot

z Turn off the power switch and unplug the machine.
x Place the presser foot so that the pin on the foot lies
1. Turn off the power switch and unplug the
just under the groove of the foot holder.
1. Turn off the power switch and unplug the
machine.
1. Turn off the power switch and unplug the
c Lower the foot holder to lock the foot into place.
machine.
v Raise the presser foot lifter to check that the presser machine.
2. Place the presser foot so that the pin on the foot
2. Place the presser foot so that the pin on the foot foot is secure.
lies just under the groove of the foot holder.
2. Place the presser foot so that the pin on the foot
q Groove
lies just under the groove of the foot holder.
lies just under the groove of the foot holder.
3. Lower the foot holder to lock the foot into place.
w Pin
3. Lower the foot holder to lock the foot into place.
3. Lower the foot holder to lock the foot into place.
4. Raise the presser foot lifter to check that the e Lever
4. Raise the presser foot lifter to check that the
presser foot is secure.
4. Raise the presser foot lifter to check that the
presser foot is secure.
presser foot is secure.
Groove
Groove
Pin Groove
Pin
Lever
Pin
Lever
Lever

Adjustment of Foot Pressure

It is not necessary to adjust the presser foot's pressure for
normal sewing.
When you sew heavy or lightweight fabrics, turn the adjusting
screw:
– clockwise for heavyweight fabric.
– counterclockwise for lightweight fabric.
* For normal sewing, set the adjusting screw so that it sits
1mm below the top of the machine.
q To decrease
w To increase
e Adjusting screw
r Top of the machine
14
9
9
9