Connecting The Machine To The Power Supply; Controlling Sewing Speed; For Your Safety - ELNA eXtend 264 Livret D'instructions

Operating Instructions
(for U.S.A. and Canada only):
The symbol "O" of a switch indicates the "off" position of the
switch.
For an appliance with a polarized plug (one blade wider than the
other):
To reduce the risk of electrical shock, this plug is intended to fit
in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
The foot controller Model YC-482J or YC-482J-EC is used with
the sewing machine Model 7034D.

Connecting the Machine to the Power Supply

Before connecting the machine to the power supply, make sure
the voltage and frequency shown on the machine conform to
your electrical power.
z Turn off the power switch, and connect the machine
plug to the machine socket.
x Connect the power supply plug to your power supply.
c Turn on the power switch.
q Power switch
w Machine plug
e Machine socket
r Power supply plug
t Power supply
y Speed controllerControlling Sewing Speed

Controlling Sewing Speed

Sewing speed can be varied by the speed controller.
The harder you press on the controller, the faster the machine
runs.
Step on the speed controller with the presser foot lifter up, and
practice controlling the speed.
q Speed controller

For Your Safety:

* While in operation, always keep your eye on the sewing
area, and do not touch any moving parts such as the
thread take-up lever, loopers, handwheel, needle or
knives.
* Always disconnect the machine from the power supply:
— when leaving the machine unattended.
— when attaching or removing parts.
— when threading or cleaning the machine.
* Do not place anything on the foot control, otherwise the
machine will start inadvertently.
6