Adjustment Of Needle Plate Setting Knob - ELNA eXtend 264 Livret D'instructions

Table des Matières

Publicité

(A)
(B)

Adjustment of Needle Plate Setting Knob

(Changing to Standard Serging or Rolled Hemming)
z Turn off the power switch and unplug the machine.
x Open the looper cover and side cover.
c Deactivate the upper knife.
v Push the cutting width adjusting dial to the right as far
as it will go, then, move the needle plate setting knob
to the guide line of S (for Standard Serging) or R (for
Rolled Hemming).
Release the cutting width adjusting dial to the left
gently.
b Set the upper knife to up position.
n Close the looper cover and side cover.
q Chaining finger
w Guide line
e Cutting width adjusting dial
r Upper knife
t Needle plate setting knob
(A)Standard Serging
* The chaining finger is located beside the needle plate
as shown in diagram (A) for guiding the flat edge of the
fabric for overlock sewing.
(B)Rolled Hemming
* Pull the needle plate setting knob from "S" to "R"
position, so that the fabric edge will be rolled for
hemming, picot edging and narrow hemming.
22
13

Publicité

Table des Matières
loading

Table des Matières