12.3
CONNECTION OF THE BALANCE TO A COMPUTER
To receive/transmit data, ensure the connector is wired as shown, to connect the balance to
the serial port of your Personal Computer as shown below:
There are three ways of transmission in which the Balance and the computer can be connected:
•
Continuous transmission of weight data (continuous mode must be set from the menu as
explained in the paragraph 10.2).
•
On demand transmission of weight data (on demand mode must be set from the menu
as explained in the paragraph 10.2).
•
On demand transmission with GLP of weight data (on demand mode with GLP must be
set from the menu as explained in the paragraph 10.2).
In all the modes, it is possible to execute all the balance's functions directly from the computer's
keyboard, transmitting to balance the ASCII codes as shown in the table below.
©Adam Equipment Co. Ltd. 2018
61