Adam Equipment Solis SAB Série Mode D'emploi page 41

5. Press the PRINT button to confirm. If the part entered is less than 100 times the resolution
of the balance, an error message will be displayed. To exit without entering the weight,
press the ON/OFF button.
6. If the weight is sufficient, "0" will be shown on the display; it is now possible to proceed
with the counting, loading the parts on the plate.
7. To exit from the part counting function, press the ON/OFF button.
It is also possible to use the optional alphanumeric keyboard to insert the average unit weight
of the sample. In this case, carry out the same procedure described above to enter manual
insertion mode.
1. Insert the sample's unit weight in grams of the sample by using the numeric keys from 0 to
9 and the decimal point.
In case of error, press the CLEAR button and restart.
©Adam Equipment Co. Ltd. 2018
39