Adam Equipment Solis SAB Série Mode D'emploi page 46

5. Once the desired value has been set, press the PRINT button.
6. It will now ask you to weigh the holder in the air.
7. Press the tare, if necessary, and load the holder. Wait for the stability symbol to appear and
press the PRINT button to acquire the value. The word 'wait...' will appear while the weight
is being taken.
8. The weighing of the holder immersed in the liquid will then be requested. Then immerse the
solid in the liquid, wait for the stability indicator to appear, and then press the PRINT button.
The word 'wait..." will be displayed while the weight is being taken.
9. The result of the density calculation of the liquid will now be displayed. If the balance is
equipped with a printer, it will be possible to print the density value by pressing the PRINT
button.
10. The following will be shown on the display in case of error:
11. Now press the ON/OFF button to exit from the density function, or the MENU button to carry
out the density measurement for another liquid.
©Adam Equipment Co. Ltd. 2018
44